Husqvarna WS 482 HF Manuel D'utilisation page 7

• Sparks can occur when you operate the product.
Make sure that you have a fire extinguisher near.
• Do not use loose clothing, jewelry or other items that
can get caught in moving parts. Put your hair up
safely above shoulder level.
Safety devices on the product
WARNING:
instructions that follow before you use the
product.
• Do not use a product with defective safety devices.
• Do a check of the safety devices regularly. If the
safety devices are defective, speak to your
Husqvarna service agent.
Blade guard
The blade guard keeps dust away from the operator and
prevents injury if the cutting blade breaks.
WARNING:
without a blade guard.
To do a check of the blade guard
1. Make sure that the blade guard is not damaged.
Product overview on page 2 .
Refer to
2. Make sure that the blade guard is correctly attached.
3. Make sure that the blade is in the center of the blade
guard and does not touch the blade guard.
Blade guard lock
The blade guard lock keeps the blade guard guide in the
correct position on the blade guard.
To do a check of the blade guard lock
• Make sure that the blade guard lock mechanism on
the blade guard guide operates correctly. Refer to
adjust the lock handle on the blade guard guide on
page 13 .
End stops
The end stops prevent the product to come off the rails.
WARNING:
attached correctly to the rail ends, the
product comes off and can cause serious
injury.
To do a check of the end stops
• Make sure that end stops are attached to the rail
Product overview on page 2 .
ends. Refer to
1675 - 001 - 11.06.2021
Read the warning
Do not use the product
If the end stops are not
Power pack
The Husqvarna power pack is used to operate the
product.
WARNING:
from the power supply and wait a minimum
of 5 minutes before you do maintenance.
To do a check of the power pack
• Do a check of the safety equipment and make sure
that it is not damaged. Refer to the Husqvarna power
pack manual.
Wall supports
The wall supports attach the rails in the correct position
on the wall.
To do a check of the wall supports
1. Put the wall supports at approximately ¼ of the
length of the rail (A).
A
2. Use a minimum of 2 wall supports during operation.
If more rails are put together, 1 wall support is
necessary for each meter of extended rail section.
Rail connectors
The rail connectors connect the rail sections.
CAUTION:
connectors are compatible with the product.
To do a check of the rail connectors
To
• Make sure that the rail connectors are assembled
correctly. The rails must be linear and the ends must
be flush in the center of the connector.
Machine stop buttons
The machine stop buttons on the power pack and on the
remote control decrease the speed of the connected
Disconnect the product
A
Make sure that the rail
7