Husqvarna WS 482 HF Manuel D'utilisation page 9

2. Drill 15 mm (5/8 in.) holes for the M12 (½ in.)
expander bolts.
3. Hang the wall supports loosely from the expander
bolts. Use M6S 12 x 70 (½ in. x 2 in.) or equivalent.
To assemble the rails
1. Put the rail in the wall supports and tighten the
compression washers. For vertical cuts, assemble
the rail with the lock handle of the saw carriage up.
2. Make sure that the rail is correctly aligned with the
tracks on the wall supports before you tighten the
screws.
3. Adjust the distance between the cut line and the wall
supports. The distance between the edge and the
inner face of the cut must be (B) = 89 mm/3.5 in.
Tighten the expander bolts.
B
To assemble the product on the rails
WARNING:
product on the rails you must assemble the
product in the saw carriage.
1. Lift the product into position in the saw carriage.
When the product is in position, the lock handle
moves up into a middle position. In this position, the
product stays in the carriage but is not sufficiently
attached to start the work.
1675 - 001 - 11.06.2021
B
Before you assemble the
2. To attach the product, lift the lock handle against the
product until the handle locks.
3. Use the pin to lock the handle.
To assemble the blade
WARNING:
from the power supply before you start the
assembly.
1. Remove dirt from the contact surfaces on the blade
flange and blade.
2. Make sure that the blade rotates with the used part
of the diamond in the rotation direction of the blade.
Note:
Because the blade rotation direction can be
selected, the water spray from the blade can also be
selected.
Disconnect the product
9