Risk Of Injury In Case Of Improper Work; Dangers Caused By The Uncontrolled Escape Of Hot Fluids; Risk Of Burns Due To Hot Components And Surfaces; Availability Of The Operating Instructions - oventrop Unibox ERTL Notice D'utilisation

Unibox E RTL
2.5.2 Risk of injury in case of improper
work
Angular components, protrusions and edges
both inside and outside the product may cause
injuries.
f Before starting work, make sure that there
is sufficient space.
f Handle open and sharp-edged compo-
nents with care.
f Make sure that the workplace is tidy and
clean to avoid accidents.
2.5.3 Dangers caused by the
uncontrolled escape of hot fluids
f Only carry out work when the product is
depressurised.
f Allow the product to cool down before
working on it.
f Check that the product is not leaking after
work is complete.
f If necessary, cover the vent holes with a
cloth as appropriate.
f Replace any defective fittings immediately.
f Wear safety goggles.
2.5.4 Risk of burns due to hot
components and surfaces
f Allow the product to cool down before
working on it.
f Wear protective clothing to avoid unpro-
tected contact with hot system compo-
nents and fittings.
2.5.5 Availability of the operating
instructions
These operating instructions and all other rele-
vant documents (e.g. operating instructions of
accessories) must be read and applied by any
person working on the product.
The operating instructions must be available at
the installation location.
f Hand these operating instructions and all
other relevant documents (e.g. accessory
manuals) over to the user.
102273180-V02.06.2019

Technical description

3. Technical description

3.1 Construction

1 2 3 4
6
Illustr. 2: "Unibox E RTL" construction
(1)
Wall installation cabinet
(2)
Valve with integrated return tempera-
ture limiter
(3)
Venting and bleeding valve
(4)
Handwheel
(5) Cover plate
(6) Valve connection G ¾ male thread
("Euro" cone according to DIN EN
16313)

3.2 Dimensions

135
Illustr. 3: Dimensions in mm
5
57
135
27