Safety-Related Information; Normative Directives; Correct Use; Modifications To The Product - oventrop Regudis W-HTE Mode D'emploi

Safety-related information

2. Safety-related information

2.1 Normative directives

Observe the legal requirements applicable at
the installation location.
The current standards, regulations and guide-
lines apply.

2.2 Correct use

Safety in operation is only guaranteed if the
product is used correctly.
The exclusive surface-mounted cabinet "Regu-
box" made of PMMA and featuring thermal
insulation reduces heat loss at the dwelling
station.
Any other use of the product will be considered
incorrect use.
Claims of any kind against the manufacturer
and/or its authorised representatives due to
damage caused by incorrect use will not be
recognised.
Observance of the operating instructions is part
of compliance with correct use.

2.3 Modifications to the product

Modifications to the product are not permitted.
In the case of modifications to the product,
the warranty will become void. The manufac-
turer will not accept liability for damage and
malfunctions caused by modifications to the
product.

2.4 Warnings

Each warning contains the following elements:
Warning symbol SIGNAL WORD
Type and source of danger!
Possible consequences if the danger oc-
curs or the warning is ignored.
f Possibilities of avoiding the danger.
The signal words identify the severity of the
danger arising from a situation.
16
DANGER
Indicates an imminent danger with high
risk. The situation will lead to death or
serious injury if not avoided.
WARNING
Indicates a possible danger with moder-
ate risk. The situation may lead to death
or serious injury if not avoided.
CAUTION
Indicates a possible danger with lower
risk. The situation may lead to minor
and reversible injury if not avoided.
NOTICE
Indicates a situation that may lead to
damage to property if not avoided.

2.5 Safety notes

The product is manufactured in accordance
with the latest technical standards and is safe
to use. However, residual dangers to people
and property may occur during installation and
operation.
2.5.1 Danger in case of inadequate
personnel qualification
Work on this product may only be carried out
by qualified tradespeople.
2.5.2 Risk of injury in case of improper
work
Angular components, protrusions and edges
both inside and outside the product may cause
injuries.
f Before starting work, make sure that there
is enough space.
f Handle open and hard-edged components
with care.
f Make sure that the work place is tidy and
clean to avoid accidents.
Regubox
134459580-V01.02.2019