Electrical Connection; Connection Of Supply Line / Commissioning - Helios MiniVent M1/100 F Notice De Montage Et D'utilisation

Installation and Operating Instructions
m
DANGER
m
WARNING
MiniVent M1/100/120 F
4 . Mounting flange MF 100 (Accessories)
For use in case of confined space in ceilings, in thin walls and narrow shafts. Attach the MF 100 to the wall
or ceiling at a right-angle (any number possible one above the other). Then secure the fan to the MF 100
with the enclosed screws (Fig. 10/11). Also suitable for assembling a pull cord switch (Accessories).
Fig .10
MF 100 attachable
Wall
6 .3

Electrical connection

m The safety instructions in section 1 .2 must be observed!
– The electrical connection and initial commissioning must only be carried out by qualified electricians
according to the information in the attached wiring diagrams .
– All relevant standards, safety regulations (e .g . DIN VDE 0100), as well as the technical connection conditions
of energy suppliers are to be adhered to!
– An all-pole mains switch/isolator, with at least a 3 mm contact opening (VDE 0700 T1 7 .12 .2 / EN 60335-1)
is mandatory!
– Network configuration, voltage and frequency must be consistent with the rating plate information .
6 .4

Connection of supply line / Commissioning

– An NYM cable must be used, commercial maximum diameter 11 mm
– Puncture cable grommet with a round tool or directly with the supply cable (Fig.9, Pos
– Remove cable jacket at least 100 mm in length. Strip insulation 7mm in length (Fig.12)
– Push cable carefully through cable grommet
– Run cable in conduit and connect according to wiring diagram (page 14)
– Check the waterproofing of the connection cable and tight clamping of the strands
– If with installed supply cable, the cable grommet does not enclose the plastic-sheathed cable evenly, the grommet
must be sealed additionally e.g. with silicone. Otherwise the IP protection expires
– The connection cable must be kept in such a way that no water can get in along the cable in case of water expo-
sure. The cable must not run over sharp edges!
– Check designated use of fan
– Compare mains voltage to rating plate data
– Check fan for solid mounting and professional electrical installation
Fig .11
MF 100
12
32
52
9
Ceiling
ä )
EN