Helios MiniVent M1/100 F Notice De Montage Et D'utilisation page 28

Installation and Operating Instructions
EN
MiniVent M1/100/120 F
– Duct inside diameter M1/100 F = 100 mm or M1/120 F = 120 mm
and distance to room corners: at least 90 mm.
– For surface installation, the casing is provided with a side entry knockout (Fig.9, Pos
– The mains supply cable is to be kept in such a way that no ingress of moisture is made possible along the
cable. The cable must not run over sharp edges!
Fig .6
Cable exit in
the dark
section
user-de-
fined .
min . 90 mm
*
Type M1/120..
2 . Drill holes:
Set casing against the wall, mark the holes and drill. Fasten with at least 2 screws and plugs.
3 . Back draught shutter and guide vane
– Guide vane must be mounted vertically (Fig.8).
Snaps into place every 90° rotation.
– Apply foam strips (Scope of delivery) prior to final installation (Fig.8)
Fig .8
When installing the unit, the
guide vane ö
ted vertically (as shown). Snaps
into place every 90° rotation.
top
ö
bottom
vertical for wall installation
Fig .7
Recommen-
ded
Cable runs under the casing . Cable
cable
length from the wall at least 180 mm .
exit optional
0 . . .-360 °,
ideally
in each
case 45 °
Drill holes
Fig .9
must be moun-
Apply foam
strips
ò
Back
draught
ò
Break out entry
ü
shutter
knockout for cable for
removable
surface mounting
ö
Guide vane
ù Condensate drain holes for
removable
ceiling installation.
8
ò ) for the cable!
ù
ù
ä