Helios MiniVent M1/100 F Notice De Montage Et D'utilisation page 30

Installation and Operating Instructions
EN
m
WARNING
MiniVent M1/100/120 F
– Check free movement of the impeller
– Check all parts for tightness, particularly screws. Do not loosen screws in the process!
– Check fan for vibrations and noises during trial run
– Compare power consumption to rating plate data
Fig .12
ò
Sealant
7 mm
100 mm
- Length of single conductor 100 mm
- Length of stripped insulation 7 mm
- Strip plastic-sheathed cable flush with conduit
6 .5 Installation
Fig .14
Duct channel
90° bend
Installation with cram-
ped space conditions
Fig .13
1. Mount cover of control board
press on casing and fasten with screws.
2. Snap in facia
Fig .15
Mount guide
Fan
vane with
back draught
shutter at the
end of the
duct or just
omit it .
Room side
10
ò
ù
Mount control
board cover
on groove,
ù
.
ò
WES 1 . . or
TWH 1 . .
Core drill
hole
M1/100 F =
Ø 115 mm
M1/120 F =
Guide vane with
Ø 130 mm
back draught
shutter
Standard install
Outside