Stopping The Alarm / Switching Off The Alarm; Audible And Visual Signals - Sygonix 2299890 Notice D'emploi

(2) will turn green to indicate that the changeover contact
has been activated. In toggle mode, a second reading of the
transponder closes the code lock.
Activating the changeover contact via the opening button
If a door opener button has been connected to the code lock,
the changeover contact can be activated by briefly pressing the
button. The activation duration is the same as the duration which
is used for a valid user transponder. In toggle mode, the opening
button changes the switch position of the changeover contact.
b) Stopping the alarm / switching off the alarm
The code lock monitors the number of opening attempts. An
alarm is triggered after ten unsuccessful opening attempts. When
the alarm is triggered, you can stop it in several ways:
The alarm can be terminated as follows using a valid transponder
or the master code.
- Hold a valid transponder over the code lock
- Enter the correct master code+

13. Audible and visual signals

The LEDs (red and green) are located on the front of the code
lock (2). The housing also contains a buzzer. The signals of both
warning systems have the following functions:
via the remote control
47