Installation And Connection; Installation - Sygonix 2299890 Notice D'emploi

7. Installation and connection

a) Installation
Ensure that the connection cables are not kinked or
squashed. This can cause malfunctions, short circuits
and device defects. Do not connect the cables when
the product is connected to a power supply.
• Remove the top part of the housing with the RFID sensor from
the mounting plate. To do this, unscrew the locking screw (4)
on the bottom with the hex key provided, and then remove the
upper part of the housing.
• Use the mounting plate as a template; place it vertically on the
mounting surface and mark the two fixing holes.
• Drill the holes and, depending on the mounting surface, insert
the dowels (included). On wood or metal surfaces, the dowels
are not required.
Use the fixing screws, and if necessary, the dowels
provided to secure the housing (when securing to
walls). Ensure that no cables or wires are damaged
when drilling holes or tightening screws.
• Hang the mounting plate on the wall. The connection cable
should be fed through the cable feed in the middle of the rear
panel.
13