Deleting All User Data - Sygonix 2299890 Notice D'emploi

• To end the deletion, press the # key to finish the deletions.
The LED indicator (2) will flash red.
• Press the
indicator (2) will switch to constant red to indicate that the
code lock is in standby mode.
f) Deleting all user data
This function allows all user data (all transponders) to be
deleted from the code lock memory. However, the configuration
information will be retained.
Proceed as follows:
• The code lock must be in standby mode and the LED
indicator must be red.
• Enable programming mode (see section 11 "Programming",
paragraph "b) Enabling/exiting programming mode"). The
LED indicator will then flash red.
Example:
• Press the
The code lock is now in delete mode. Enter the master code
again.
e.g.:
• Press the
briefly turn green, and then orange again.
• All user data (transponders) will be deleted.
36
key to exit programming mode. The LED
key. The LED indicator will light up orange.
key to confirm your entry. The LED indicator will