Operation; Activating The Changeover Contact (Opening And Closing The Door) - Sygonix 2299890 Notice D'emploi

Both master transponders will also be re-added as
master transponders. Scan the "Master Add Card"
first, followed by the "Master Delete Card". If this
sequence is not observed, both transponders will be
reprogrammed to the function of the other card. The
labels may then have to be changed by re-labelling the
cards, or you may have to perform the reset process
again in order to reprogram the master transponders
according to the labels.
• The first transponder to be scanned is the one used to add new
transponders (= "Master Add Card").
• The second transponder to be scanned is the one used to
delete previously added transponders (= "Master Delete
Card").
Any programmed user information and transponder
information will be retained after a factory reset.

12. Operation

a) Activating the changeover contact (opening
and closing the door)
Activating the relay with a user transponder (EM card)
The transponder must be held in front of the sensor surface (at a
maximum distance of approximately 4 cm). If a valid transponder
is detected, the code lock will emit a beep and the LED indicator
46