Configuring Visual Warnings - Sygonix 2299890 Notice D'emploi

• Enter the desired function:
= Alarm and control tones of the code lock are switched
off.
= Alarm and control tones of the code lock are switched
on.
Tones are switched on by default.
• To exit programming mode, press the
indicator will switch to constant red to indicate that the code
lock is in standby mode.
j) Configuring visual warnings
You can turn the indicator and warning signals of the code lock
on or off.
To configure the LED indicator, proceed as follows:
• The code lock must be in standby mode and the LED
indicator must be red.
• Enable programming mode (see section 11 "Programming",
paragraph "b) Enabling/exiting programming mode"). The
LED indicator will then flash red.
Example:
• Press the
briefly turn green, and then orange again.
• Press the
42
key to confirm your entry. The LED indicator will
key. The LED indicator (2) will turn orange.
key. The LED