Operation; Remote Control; Code Lock - Sygonix 2299890 Notice D'emploi

9. Operation

a) Remote control
• If a small transparent plastic strip protrudes from the bottom of
the IR remote control, the battery is already inserted. Pull the
plastic strip out of the IR remote control. The remote control will
then be ready for use.
• Change the battery when the code lock stops responding
to the remote control under normal conditions (and you are
sure that the infrared sensor (5) is clean and that there are
no obstructions).
• To change the battery, pull out the battery holder (7) on the
bottom of the IR remote control. Replace the depleted battery
(1x CR2025) with a new one. Push the correctly oriented
battery holder back into the IR remote control (the plus pole/+
of the battery should point towards the bottom of the IR remote
control).
A battery change is required if the range decreases
significantly over time or the code lock stops responding
to the remote control.
b) Code lock
• After completing the installation and connection process,
switch on the operating voltage.
• The code lock will emit a short beep. The LED indicator on the
top of the code lock will be bright red.
21