Using The Master Transponder - Sygonix 2299890 Notice D'emploi

• Enter the desired function:
= LED indicator of the code lock is switched off.
= LED indicator of the code lock is switched on.
The LED indicator alerts are switched on by default.
• To exit programming mode, press the
indicator will switch to constant red to indicate that the code
lock is in standby mode.
k) Using the master transponder
Adding user transponders with the "Master Add Card"
transponder
The product comes with a special transponder labelled "Master
Add Card". This transponder allows user transponders to be
added quickly and efficiently, as it is not necessary to enter codes
via the IR remote control.
Proceed as follows:
• The code lock must be in standby mode and the LED
indicator (2) must be red.
• Hold the supplied programming transponder (labelled
"Master Add Card") in front of the RFID sensor surface (1)
on the code lock.
• To add a user transponder, hold it in front of the RFID sensor
surface (1).
key. The LED
43