Restoring Factory Settings - Sygonix 2299890 Notice D'emploi

• When the transponder has been detected, the code lock will
beep and the LED indicator (2) will briefly turn green. The
LED indicator (2) will then turn orange again.
• The user transponder is now deleted.
If the transponder cannot be found in the code lock
memory, the code lock will emit 3 short beeps and the
LED indicator (2) will flash red before switching back to
orange.
• You can now delete another user transponder. Simply hold it in
front of the code lock and confirm the entry as described above.
• To end the deletion process, hold the supplied delete
transponder (labelled "Master Delete Card") in front of the
RFID sensor surface (1) on the code lock.
• The LED indicator (2) will switch to constant red to indicate
that the code lock is in standby mode.
l) Restoring factory settings
• Switch the power supply off.
• Press and hold the open button while switching the power
supply back on. You will hear two short beeps. Wait until the
LED indicator (2) turns orange. Release the button when you
see this signal. Then scan both of the master transponders one
after another (labelled "Master Add Card" and "Master Delete
Card") on the RFID sensor surface (1) on the code lock.
• All the settings will be reset to the default factory values. The
LED indicator (2) will then switch to constant red to indicate
that the code lock is in standby mode.
45