Changing The Master Code - Sygonix 2299890 Notice D'emploi

Exiting programming mode:
• Press the
Programming mode exits automatically after 30
seconds if no programming commands are made. The
code lock will then return to standby mode (the LED
indicator (2) will turn red).
c) Changing the master code
• The code lock must be in standby mode and the LED
indicator (2) must be red.
• Enable programming mode (see section 11 "Programming",
"b) Enabling/exiting programming mode". The LED indicator
(2) will then flash red.
Example:
• Press the
• Enter the new master code,
e.g.:
The master code must always consist of six digits.
• Press the
code again to confirm:
• Press the
will briefly light up green to confirm your entry before flashing
red.
key. The LED indicator (2) will stay constant red.
key. The LED indicator (2) will turn orange.
key to confirm your entry. Enter the new master
key to confirm your entry. The LED indicator (2)
(factory setting)
25