Adding User Transponders - Sygonix 2299890 Notice D'emploi

• Press the
indicator (2) will switch to constant red to indicate that the
code lock is in standby mode.
d) Adding user transponders
General information:
• User transponders can be assigned to a specific user ID
(a number from
beginning).
• User transponders can also be added without a user ID. This
speeds up the process.
• If a user ID is not specified when a transponder is added, the
code lock will automatically assign the next available user ID.
However, it will not then be possible to determine which ID
was assigned.
If you do not assign a specific user ID to a user and
record it in a list, this can lead to problems later.
If an employee leaves the company or loses a user
transponder, you will not know which user ID to delete.
Instead of simply deleting a user ID with the
corresponding transponder, all data stored in the code
lock would have to be deleted for security reasons in
order to prevent unauthorised access.
26
key to exit programming mode. The LED
.... to , without "0" at the