Setting The Alarm Duration - Sygonix 2299890 Notice D'emploi

• Enter the desired function:
= Alarm is switched off.
= Code lock is locked for 10 minutes.
= The alarm sounds for the set time or until it is switched
off in a valid manner within this period (by entering the master
code+
• Press the
will briefly turn green and then flash red.
• To exit programming mode, press the
indicator (2) will switch to constant red to indicate that the
code lock is in standby mode.
h) Setting the alarm duration
The alarm duration (for the security function and sabotage alarm)
can be set (from 1 to 3 minutes, default setting = 1 minute). To set
the alarm duration, proceed as follows:
• The code lock must be in standby mode and the LED
indicator (2) must be red.
• Enable programming mode (see section 11 "Programming",
paragraph "b) Enabling/exiting programming mode"). The
LED indicator (2) will then flash red.
Example:
• Press the
40
or by presenting a valid transponder).
key to confirm your entry. The LED indicator (2)
key. The LED indicator (2) will turn orange.
key. The LED