Installation Instructions - Sharp Drawer Swb3085Hs Instructions D’installation

INSTALLATION INSTRUCTIONS

IMPORTANT: This appliance shall be installed only by authorized
persons and in accordance with the manufacturer's installation
instructions, local gas fitting regulations, municipal building codes,
electrical wiring regulations and local water supply regulations.
STEP 1 - UNPACK THE OVEN
WARNING
EXCESSIVE WEIGHT HAZARD
Use two or more people to move and install oven.
Failure to do so can result in back or other injury.
1 Using two or more people, remove the oven and set it on cardboard
to avoid floor damage.
NOTE: Do not use the handle or any portion of the front frame
for lifting.
2 Remove the shipping materials and tape from the oven. Do NOT
remove tape from the microwave drawer until installation is
complete.
3 Remove the hardware package from inside the bag containing
literature.
4 Remove and set aside racks and other parts from inside the oven.
5 Move the oven on the cardboard near where it will be installed.
STEP 2 - REMOVE THE OVEN DOOR
IMPORTANT: The oven door is heavy and fragile, and the door
front is glass. To avoid oven door glass breakage, use both hands,
and grasp only the sides of the oven door to remove. Do NOT lift
the door by the handle.
1 Open the oven door.
2 Locate the door latches in both corners of the oven door, and rotate
the latches forward to the unlocked position.
3 Grasp the edges of the oven door with both hands, keeping the door
slightly ajar. Lift up and pull oven door toward you to remove. Set
the oven door(s) aside on a covered work surface.
STEP 3 - REMOVE SHIPMENT SCREWS
Remove the four screws (two on each side) at the bottom of the
drawer. Discard these screws.
NOTE: Do NOT remove tape from drawer until installation is
complete.
6