Operating The Revolving Console; Initial Operation - HASE Delhi 114 Mode D'emploi

Delhi
Sekundärluftschieber
5. Operating the Revolving Console
The Delhi features a revolving console as a standard feature.
To unlock the swivel console, pull the air-damper until a slight
resistance is felt and you can see the notch. (fi g. 3).
Now turn the Delhi to the desired position and fi x this into
position by pressing in the air-slider.
The Delhi has a maximum rotational angle of 84 degrees; you
can adjust the rotational angle in 14-degree increments.
fi g. 3
WARNING!
Never turn stove when lighting fi re!
In the whole rotational area range, the safe
distances (radiation area) apply to distances to
fl ammable materials.
36
2. Vorbereitung zur Montage
2.5 Drehwinkel am Aufstellort einstellen
fi g. 4
fi g. 5
6. Initial Operation
NOTE!
During shipment, condensation moisture can
accumulate in the stove's interior, which may
possibly lead to the appearance of condensation
or water on the stove or fl ue pipes. Please dry
off these damp areas immediately.
The surface of your stove was treated in a sandblasting ma-
chine before applying the colour coating. Despite careful and
thorough inspection, there may still be some residual material
in the stove body, which can fall out when your stove is being
installed.
NOTE!
To prevent any damage, please immediately va-
cuum up these small steel pellets with a vacuum
cleaner.
The fi rst time a stove is operated, the heat development
causes the emission of volatile components from the coating,
sealing strips and lubricants, and smoke and odours can occur.
At a higher combustion temperature, this one-time process
can take between 4 to 5 hours.
To achieve this higher combustion temperature, please in-
crease the fuel quantity recommended in Section 8, „Adding
Fuel/ Heating with Nominal Thermal Output", by approxima-
tely 25%.
CAUTION!
To prevent adverse effects on health, nobody
should stay in the room(s) during this process
unless absolutely necessary. Make sure the