Operating The Revolving Console; Initial Operation - HASE Bari C.11 Mode D'emploi

5.

Operating the Revolving Console

The Bari has a maximum rotational angle of 180 degrees;
you can adjust the rotational angle in 15-degree increments.
Unlock the rotary console by briefl y pressing the button A
and then turn the Bari to the desired position. Shortly before
the fi nal position is reached, press the key A again and lock
the stove into place with a slight rotational movement.
A
fi g. 3
WARNING!
Never turn stove when lighting fi re!
In the whole rotational area range, the safe
distances (radiation area) apply to distances
to fl ammable materials.
fi g. 4
fi g. 5

6 . Initial Operation

NOTE!
During shipment, condensation moisture can
accumulate in the stove's interior, which may
possibly lead to the appearance of
condensation or water on the stove or fl ue
pipes. Please dry off these damp areas imme
diately.
The surface of your stove was treated in a sandblasting ma-
chine before applying the colour coating. Despite careful and
thorough inspection, there may still be some residual material
in the stove body, which can fall out when your stove is being
installed.
NOTE!
To prevent any damage, please immediately
vacuum up these small steel pellets with a
vacuum cleaner.
The fi rst time a stove is operated, the heat development
causes the emission of volatile components from the coating,
sealing strips and lubricants, and smoke and odours can occur.
At a higher combustion temperature, this one-time process
can take between 4 to 5 hours.
To achieve this higher combustion temperature, please incre-
ase the fuel quantity recommended
in Section 9, „Adding Fuel/ Heating with Nominal Thermal
Output", by approximately 25%.
CAUTION!
To prevent adverse effects on health, nobody
should stay in the room(s) during this process
33