Adding Fuel / Heating At Nominal Thermal Output; Heating With Brown Coal Briquettes; Banking The Fire And Raising The Temperature - HASE Como Manuel D'utilisation

7. Adding Fuel / Heating at Nominal
Thermal Output
More fuel should be added to the fire when the
flames from the previous burning off phase have just
gone out.
Adding Fuel / Heating at Nominal Output
Procedure Position of
Control Elements
Adjust primary and Close primary air slider (I),
secondary air. set secondary air slider
(II) between position 2 and
3. (fig. 4)
Close fire grate. Push in fire grate slider.
Add two logs weighing ap-
prox. 1,7 kg in total. Place
logs with one end to the
front of fire box. Only add
a single layer of fuel.
Tab. 2
fig. 4
CAUTION!
Please ensure that the logs are inserted
with sufficient distance (at least 5 cm)
from the furnace window.
8.

Heating with Brown Coal Briquettes

Wood should be used for the warming-up phase and
when adding fuel for the first time, see "Warming-
up Phase". As soon as a basic glowing firebed is
reached, place 2-3 brown coal briquettes on the
grate in the middle of the firebox, keeping a finger's
width between the briquettes, and use the following
procedure and settings:
Heating with Brown Coal Briquettes
Procedure Position of
Control Elements
Open primary air com- Pull primary air slider all
pletely. the way out (fig. 5)
Adjust secondary air. Set secondary air slider to
position 2. (fig. 5)
Open fire grate. Pull out fire grate slider.
Place three brown coal
briquettes, amounting to
approx. 1.7 kg in total, in
the centre of the grate with
a gap the width of one
finger between each one.
Only place one layer of
fuel on top of this.
Tab. 3
fig. 5
9. Banking the Fire and Raising the
Temperature
Keep the stove set as described above until the
brown coal briquettes are thoroughly burnt. Then
close the primary air (I) and the fire grate. Slide the
secondary air slider (II) to position 2/3.
CAUTION!
While the stove is in operation, the sec-
ondary air slider should never be com-
pletely closed.
To raise the temperature of the fire, stir up the rest
of the glowing embers with the fire grate slider.
Open the primary air (I) and add new logs to the fire.
GB
35