Adding Fuel / Heating At Nominal Thermal Output; Emptying The Ash Drawer - HASE Delhi 114 Mode D'emploi

8. Adding Fuel / Heating at Nominal Thermal Output
More fuel should be added to the fire when the flames from
the previous burning off phase have just gone out.
Adding Fuel / Heating at Nominal Output
Procedure
Adjust secondary air. Set air slider to between
position 2 and 3.
Add two logs weighing approx.
1.3 kg (Delhi 114) / 1.6 kg
(Delhi 124) in total. Place logs
with the end to the front of fire
box. Only add a single layer
of fuel.
Close fire box door.
Tab. 2
38
Delhi
9. Emptying the Ash Drawer
As a safety precaution, please make sure that you only dispose
of ashes once they are cold. While the ash collects during the
fire, the lid (fig. 8/1) is located under the ash drawer (fig. 8/2).
The ash drawer contains the mineral components of the wood
Position of
(approx. 1%) as combustion residues.
Control Elements
Delhi
Remove both the ash drawer (fig. 9/2) and the lid (fig. 8/1) lo-
cated underneath it. Make sure the ash does not pile up all the
way to the bottom of the fire box. Slide the lid (fig. 9/1) onto
the ash drawer so that it is closed; this prevents ashes from
flying around, which in turn means your home stays clean.
fig. 8
fig. 9
2
1
1
2