Heating At Low Thermal Output (During Transitional Seasons); Emptying The Ash Drawer; Cleaning The Ceramic Glass Panel - HASE Como Manuel D'utilisation

10. Heating at Low Thermal Output
(during Transitional Seasons)
You can vary the thermal output of your Como by
adjusting the quantity of fuel used.
NOTE!
Do not attempt to slow down the com-
bustion by reducing the air supply. When
heating with wood, this can result in an
incomplete burning process and pose the
risk of an explosive like combustion of the
accumulated wood gases (deflagration).

11. Emptying the Ash Drawer

As a safety precaution, please make sure to wait
until the ashes are cold before you dispose of them.
While the ash collects during the fire, the lid is lo-
cated under the ash drawer.
Remove both the ash drawer and the lid located un-
derneath it. Slide the lid onto the ash drawer so that
it is closed; this prevents ashes from flying around,
which in turn means your home stays clean. To
place the ash drawer back into the stove, proceed
in the reverse order.
CAUTION!
Piled up ashes can impair or even block
the supply of primary air supply to the
stove. Please ensure that the air supply
path for the primary air between the ash
drawer and the bottom of the ash compart-
ment remains clear.
36

12. Cleaning the ceramic glass panel

To clean use the included protective glove with an
extra long shaft. This protects you and your clothing
from getting dirty.
We recommend a proven and environmentally
friendly cleaning method:
Ball some up paper towels or newspaper, moisten
the ball, dip it into the cold wood ash, rub the panel
with it and then wipe the glass with a clean, dry ball
of paper.
NOTE!
Only use wood ash from split logs for this
cleaning process. Wood briquettes can
contain additives, which may scratch the
surface of the ceramic glass.
A common, retail glass detergent may also be used
for cleaning. When cleaning the seal and steel sur-
faces we recommend that you spray the glass deter-
gent on a cloth and not directly on the pane.