Cleaning And Care; Specifications; Disposal - Gazzini 10035330 Instructions De Montage Et Mode D'emploi

on-board voltage (6/12 volts) divided by the watt difference
between the old and the new turn signal.
The original wattage can either be found on the original bulb
itself, in the vehicle handbook or on the turn signal lens.
Example: A 7.5-ohm resistor simulates 19.2 watts, an 8.2-ohm
resistor simulates 17.6 watts and a 10-ohm resistor simulates
14.4 watts. The resistors are available partly prewired and can
therefore be installed particularly easily; an incorrect connection
is no longer possible.
The special flasher unit with order no. 10033844 (operating
range of 1 to 30 W) for LED turn signals can only be used if the
vehicle is equipped with two turn signal indicator lights. If, on
the other hand, there is a common turn signal indicator light for
the right and left turn signal circuit, or a hazard warning flasher
system or an acoustic turn signal, malfunctions may occur – in
these cases, resistors should be used.
Please keep in mind that if electronic flashers are used, the
failure of a turn signal is no longer indicated by the indicator
light. Therefore, carry out a function check before every journey.

7 | CLEANING AND CARE

Use warm soapy water or a motorcycle cleaner and a soft cloth
for cleaning the turn signals. Do not use a harsh cleaner that
could corrode the aluminium and do not use a high-pressure
cleaner, as this can destroy seals and drive water into the turn
signal. Afterwards, use a wax-based product which will protect
the surfaces against the elements.

8 | SPECIFICATIONS

Ø: 35 mm
T: 15 mm
12 V/2,7 W

9 | DISPOSAL

Packaging disposal:
Please dispose of the packaging appropriately. Dispose of
20