Storage - Gazzini 10035330 Instructions De Montage Et Mode D'emploi

could impair the safety of the vehicle and/or damage it.
 Check that the turn signals are properly secured and
functioning correctly before every journey.
 Ensure that commissioning is performed properly. In doing
so, follow these installation instructions.
 Before carrying out any work on the vehicle electrical system,
be sure to disconnect the vehicle battery – there is a danger
of short-circuit!
 When carrying out assembly work, ensure that the vehicle is
in a safe position and that the workplace is well lit.
 The turn signal should be installed in a way that protects it
from vibrations, as in extreme cases, vibrations can destroy
the circuit board of the LEDs (rubber-mounted handlebar
clamps generally offer sufficient vibration protection).
 Make sure that the throttle twistgrip can move freely and can
spring back by itself.
 The electrical as well as mechanical installation on the
vehicle must be carried out correctly. Incorrect installation
can cause short-circuits or invalidation of the type-approval.
 The electric cables must not be subjected to any tensile
forces, even when the steering is in full lock. The cables
must be routed in such a way that they cannot chafe and
they must not bend. If necessary, an extra cable sheath or a
rubber cable feed-through can be used.
 Any resistors that are installed may heat up during use and
therefore must not be installed in the direct vicinity of heat-
sensitive components or in closed housings. Depending on
the duty cycle of the turn signals, temperatures of 80°C or
more may occur during operation. Only resistors with a heat
sink may be used.
 The turn signal itself also warms up during operation – skin
contact must therefore be avoided.
 Keep plastic films and other packaging materials away from
children. There is a danger of suffocation.

5 | STORAGE

Store the turn signal indoors for protection against the weather
and moisture. Humidity should not exceed 80%.
15