Specifications; Storage - Gazzini 10036243 Traduction Du Mode D'emploi Original

left turn signal circuit (either at the front or the rear).
The required resistance can be determined using the following
formula:
Required resistance R (in ohms) is equal to the square of the
electrical system voltage (6/12 volts) divided by the watt
difference between the old and the new turn signal.
The original wattage can either be found on the original bulb
itself, in the vehicle handbook or on the turn signal lens.
Example: A 7.5 ohm resistor simulates 19.2 watts, an 8.2 ohm
resistor simulates 17.6 watts and a 10 ohm resistor simulates
14.4 watts. The resistors are available partly pre-wired, so they
are very easy to install and it is impossible to connect them
incorrectly.
The special flasher unit (optional) with the product no.
10033844 (operating range of 1 to 30 W) for LED turn signals
can only be used if the vehicle is equipped with two turn signal
indicator lights. If, on the other hand, there is a common single
turn signal indicator light for the right and left turn signal circuit, or
a hazard warning flasher or an acoustic turn signal, malfunctions
may occur – in this case, resistors should be used.
Please keep in mind that when electronic flasher relays are used,
the failure of a turn signal is no longer indicated by the indicator
light.

5 | SPECIFICATIONS

Voltage/wattage Height
12 V/ 2,7 W

6 | STORAGE

Prior to installation, store the turn signal in a closed room that
is protected against the weather and moisture. The air humidity
should not exceed 80%.
18 mm
Width
23 mm
Depth
18 mm
23