Preparation; Installation - Gazzini 10036243 Traduction Du Mode D'emploi Original

Angle of geometric visibility:
Horizontal
20°
80°

4.2 | Preparation

Place the motorcycle securely on the stand. Disconnect the
vehicle battery by releasing the earth (ground) connection
(black cable). Then remove the front turn signals that you wish to
replace and disconnect the connecting cables. Thoroughly clean
the area in which the gazzini adhesive turn signal is to be fitted.
Remove any loose paintwork or coatings from the gluing spot.

4.3 | Installation

CAUTION!
Risk of injury!
To ensure the safety of the vehicle, the turn signal
must be securely and firmly fixed – if a turn signal
falls off while you're riding your bike, it could
cause an accident.
Therefore, proceed as follows:
The surface for the base of the gazzini adhesive turn signal
must be even, clean and free from grease in order to ensure
a sufficiently secure adhesive connection. Clean the surface
thoroughly with silicone remover. Take an adhesive pad, remove
the protective film from one side and stick the adhesive pad
to the surface. Remove the protective film from the other side.
Thread the cable of the gazzini adhesive turn signal (3) through
the drilled hole prepared beforehand. Align the turn signal
carefully (also make sure that is symmetrical with the opposite
side). Now place the base of the gazzini turn signal exactly in
the selected position on the adhesive pad, and press it firmly
Vertical
15°
15°
21