Preparation; Attachment - Gazzini 10036658 Traduction Du Mode D'emploi Original

If the motorcycle is registered according to German law (older
vehicles prior to 1998), please observe the following provisions in
accordance with the German Road Traffic Licensing Regulations
(StVZO) during installation:
• Distance between the rear turn signals of at least 240 mm (inside
edge of turn signal lens to inside edge of turn signal lens)
• Distance between the front turn signals of at least 340 mm
(inside edge of turn signal lens to inside edge of turn signal lens),
whereby each is 100 mm from the headlight (edge to edge)
• Minimum height above the road/ground 350 mm (bottom edge)

4.2 | Preparation

First check whether the inside diameter of the gazzini Fork-Mount
Turn Signal matches the outside diameter of the fork tube. Put your
motorcycle on its stand and make sure it cannot topple over. Then
disconnect the battery. To do so, disconnect the short-circuit to
chassis (black cable) and make sure that the power cable does not
establish a contact with the battery. Then, remove the existing turn
signals which are to be replaced, and disconnect the power cables.

4.3 | Attachment

25