Power Cord/Power Connection; Foot Control Cable Assembly Connection; Water Supply Line Connection; Lavage Control Detachable Handpiece Cable Assembly Connection - DENTSPLY Cavitron Select SPS Instructions D'utilisation

Section 5: Installation Instructions for Cavitron Section 5: Installation Instructions for Cavitron Select™ SPS™ Ultrasonic Scaler, cont'd Section 5: Installation Instructions for Cavitron

5.5 Power Cord/Power Connection

• Verify the Power Control knob is set to the OFF position
before proceeding.
• Plug the detachable AC cord into the back of the Medically
Approved Power Supply.
• Plug the power supply outlet into the back of the System.
• Plug the 3 prong grounded plug into an approved outlet.

5.6 Foot Control Cable Assembly Connection

Align the Foot Control plug with the receptacle on the back of the
System and push it in until firmly seated.
Select™ SPS™ Ultrasonic Scaler, cont'd
® ® ® ®

5.7 Water Supply Line Connection

• Push the blue hose into the orange water receptacle until the
hose cannot be pushed in any further.
• Connect the free end of the system's water supply line to the
office water supply line.
• Inspect all connections to make certain there are no leaks.
• To remove water line from Cavitron
turn off or disconnect water supply line FIRST, then push
on outer orange ring of the outlet and gently pull out
water hose.
5.8 Lavage Control Detachable
Handpiece Cable Assembly Connection
• Plug the Handpiece outlet into the receptacle on the back
of the System.
• Holding the Handpiece Cable Assembly seat male connector
into appropriate female connector.
• Once seated, snap male connector into female connector by
pushing on the end of the male connector.
• Rotate Lavage Control on the handpiece to middle setting.
• Turn on the on/off switch (power adjustment).
Select™ SPS™ Scaler,
®
ENGLISH • 5