Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
GB
ELECTRIC CONNECTIONS
Term. n.
1 (L)
230V
2 (N)
BSC
3,15 (com)
4
8K2*
BSA
3,15 (com)
5
8K2*
FT1
3,15 (com)
6
FT2
3,15 (com)
7
J1
3,15 (com)
8
J2
3,15 (com)
9
PC
3,15 (com)
10
PA
3,15 (com)
11
3,15 (com)
PED
12
3,15 (com)
STP
13
P/P
3,15 (com)
14
43
Function / Device
power supply input
Safety edge input
Cuts in during CLOSING
Safety edge input
Cuts in during OPENING
Photoelectric cell input
Photoelectric cell input
Input for selectable functions
Input for selectable functions
Command input
CLOSE
Command input
OPEN
PEDESTRIAN command input
STOP button input
STEP BY STEP command
V/I max
/
230/1A
/
Connect to the 230V power supply.
Input for closing direction enabled. Connect 8,2K safety
edges or an N.C. contact with 8,2K resistance in series (fig.
8K2/NC
/
E). If unused (binding post free), set dip 1 to ON (part. 23 fig.
A).
Input for opening direction enabled. Connect 8,2K safety
edges or an N.C. contact with 8,2K resistance in series (fig.
8K2/NC
/
E). If unused (binding post free), set dip 2 to ON (part. 23 fig.
A).
Travel direction inversion during closing.
NC
/
If unused (binding post free), set dip 3 to ON (part. 23
fig. A).
Temporary movement block during the opening stage.
Travel direction inversion during closing.
NC
/
If unused (binding post free), set dip 4 to ON (part. 23
fig. A).
See dip-switch setting 3 and 4 (part. 19 fig. A).
/
If unused, set dips 3 and 4 to OFF and then set dip
-
5 (part. 23 fig. A) to OFF.
See dip-switch setting 3 and 4 (part. 19 fig. A).
/
If unused, set dips 3 and 4 to OFF and then set dip
-
6 (part. 23 fig. A) to ON.
CLOSING only command, during opening it inverts
NO
/
and closes.
OPENING only command, during closing it inverts
NO
/
and opens.
With a 2 motor installation, only M1 opens.
With a 1 motor installation it opens partially for a set
NO
/
amount of time (see "programming pedestrian
opening").
Blocks all functions.
NC
/
If unused, set dip 7 to ON (part. 23 fig. A)
/ NO
See settings for dip 1 and 2 (part. 19 fig. A)
Notes
Publicité
Table des Matières
