Eurosystems La Zappa Mode D'emploi page 8

7. Start the cultivator standing behind the handlebars. The operator's position must be the same ( i.e. standing behind) at all times.
8.Do not touch/change safety/protecion devices. If the operator releases the lever, the motor/rotavators/tines must switch off.
9. When the cultivator blades are in action, bear in mind the risk of injury to the feet: wear solid/suitable shoes and do not get near to the cultivator
blades.
10. Before starting the machine , check the area to be worked for foreign bodies and stones.
11. In the case of an obstacle being hit which stops the machine, contact a service dealer to check it.
12. If the operator needs to lift up the blades from the ground for any reason, the machine must be switched off and the rotavators/tines must be at
a standstill.
13. Do not store the cultivator with plug inserted in the socket.
14. Do not sprinkle water on the cultivator and keep it protected from humidity.
15. Please note that our company assumes no responsability for damages due to: a) repairs made by unspecialized/unauthorized aftersales
service centers and/or (b) use of other than ORIGINAL SPARE PARTS. The same conditions apply to the accessories.
I
CULTIVATOR ASSEMBLY
Unless otherwise agreed , the cultivator is delivered partly disassembled and suitably packed. In order to complete the assembly, please proceed as
follows: Introduce the drawbar ( 46) into the arm end and secure it with a safety pin (47).
I
HANDLEBAR SUPPORT & HANDLEBAR ASSEMBLY
Assemble the support (35) on the machine with the 4 screws (36) and the corresponding washers (38) first into the 2 holes and then in the 2 slots. Fix the
handlebars (2 and 3) to the support (35) using the screw (14) the washers (15 and 17) and the knob (18) into the upper hole; the screw (19), the washer
(15) the nut (6) in the lower hole. Adjust the handlebars height acting on screws (36) fixing the support in correspondance with the the slots. Fix the plastic
support (8) to the handlebars (2/3) with the screw (11), the washers (12) and the nut (6). Screw the wire supporting rod (10) to the link stud (8) with the
thread , the washers (7) and the nuts (6/9): please consider that the rod can turn to 180°C according to better positioning of the electric wire.
I
CULTIVATOR STARTING OPERATION
- Insert the plug into the socket .
- Push the orange button (4) and, at the same time, pull the switch lever. Smoothly release the button , keeping the lever pulled. Lower the rotavators/
tines into the ground to start working. If you want to switch the machine off and pull out the rotavators/tines, release the lever.
- Inside the switch (4) there is a safety device that, in case overload occurs, stops the motor. If this happens, PLEASE WAIT FOR A FEW MINUTES,
and then try the starting operation again. It is important to check and eliminate the reason for the overload which can be caused by prolonged use of
the machine and/or functional defects.
- N.B. The electric motor does not have, at the start-up, the same torque as a petrol engine. When you switch the cultivator on it is necessary to keep
the rotavators/tines off the ground. As soon as the maximum speed is reached you can start working.
I
CULTIVATOR DISASSEMBLY
Switch off the machine and remove the plug from the mains socket (56) , disassemble the rotavators/tines by use of a centre punch, clean and slightly
5
grease the shaft then replace with any new accessories.