RIDGID R4092 Manuel D'utilisation page 36

ADJUSTMENTS
ALIGNING THE LASER GUIDE LINE
See Figure 59.
DANGER:
Laser radiation. Avoid direct eye contact with light
source.
WARNING:
Use of controls or adjustments or performance of
procedures other than those specified herein can
result in hazardous radiation exposure.
 Using a straight edge or square, draw a mark on the tile
with a marker or grease pencil.
 Lock sliding table and secure frame.
 Place the material on the table and firmly against the miter
guide and fence.
 Plug the saw into the power source and make a slight
cut to score the tile.
 When the cut is made, turn the saw OFF. Wait for the
cutting wheel to come to a complete stop.
 Roll sliding table away from cutting wheel.
 Turn on the laser.
HORIZONTAL
ADJUSTMENT
SCREW
ANGLE
ADJUSTMENT
SCREW
LOCK
SCREW
To adjust the laser angle:
 Loosen the lock screw a 1/4 of a turn so the laser can be
adjusted.
NOTE: Do not remove the lock screw.
 Using the 5 mm end of the hex key, rotate the angle ad-
justment screw. The laser angle will rotate in the same
direction as the screw.
 Rotate the laser angle clockwise or counter-clockwise
until properly aligned with the cut in the tile.
 Once aligned, tighten the lock screw.
To adjust the laser left or right:
 Loosen the horizontal adjustment screw on the laser
bracket.
 Move the laser bracket left or right until the laser is properly
aligned with the cut in the tile.
 Once aligned, tighten the adjustment screw, then close
and lock the wheel guard.
NOTE: Always make practice cuts on scrap material before
cutting through your workpiece.
BRACKET
36 — English
Fig. 59