RIDGID R4092 Manuel D'utilisation page 16

ASSEMBLY
ATTACHING WATER TRAY TO WSUV
See Figure 16.
 Open the WSUV
stand as described on page 23.
™
 Place the water tray on the WSUV
in the water tray with the holes in the WSUV
handles.
NOTE: The portion of the water tray with the Ridgid logo
should be on the wheel side of the stand.
 Secure the water tray to the stand using four hitch pins.
INSTALLING WATER FILTER AND WATER
PUMP
See Figures 17 - 19.
The water pump recirculates water from the tray to the
cutting wheel.
 Locate filter slots and pump well in water tray. Pump well
is marked, "PUMP".
 Slide filter into filter slots, as shown.
 Locate the "Max/Min" water flow selector on the pump.
For best performance, start with the flow to "Max" to
control the flow of water over the wheel.
NOTE: Water flow can be adjusted during use by
removing the filter, reaching into water well and turning
flow selector on pump. Reinsert filter.
 Place water pump into pump well.
HITCH PIN
WSUV STAND
™
STAND
™
stand. Align the holes
™
stand's
™
WATER TRAY
Fig. 16
16 — English
WATER
FILTER
PUMP WELL
FILTER SLOTS
WATER
FLOW
SELECTOR
WATER PUMP
WATER
HOSE
NOTCH
POWER
CORD
NOTCH
POWER CORD
WATER TRAY
Fig. 17
MAXIMUM
FLOW
MINIMUM
FLOW
Fig. 18
PUMP
WELL
Fig. 19