RIDGID R4092 Manuel D'utilisation page 34

ADJUSTMENTS
 Loosen the cap screws located on the front right side
and the rear left side of the frame.
 Turn the adjustment screws on the front and rear of the
frame to adjust the position of the rails.
 Move the sliding table along the frame to ensure that the
rollers are sliding properly.
 Tighten the cap screws located on the frame and bracket
to hold adjustments.
NOTE: Check that frame slides properly after each
adjustment.
TO ADJUST THE SLIDING TABLE
See Figure 56.
If the table doesn't slide smoothly, seems too loose on the
frame, moves side to side, or is visibly off track, adjustments
may be required.
 Remove frame and sliding table from the saw.
 Turn the frame and sliding table upside down and locate
the adjustable rollers.
 Loosen the adjutsment and pivot screws.
NOTE: The adjustment screws are seated inside slots in
the bracket.
 Move the brackets in or out until the rollers are touching
the frame rails. Tighten adjustment screws and pivot
screws.
 Move the sliding table along the frame to ensure that the
rollers are sliding properly.
 If further adjustments are required, repeat the steps above
until sliding table moves properly.
FRAME
ADJUSTMENT
SCREW
CAP
SCREWS
SAW
FRONT
Fig. 54
SLOT
ADJUSTMENT
SCREW
34 — English
ADJUSTMENT
FRAME
ADJUSTMENT
SCREW
PIVOT
SCREW
SCREW
CAP
SCREWS
SAW
REAR
Fig. 55
ADJUSTABLE
ROLLERS
FRAME
RAIL
BRACKET
Fig. 56