RIDGID R4092 Manuel D'utilisation page 23

ASSEMBLY
FILLING/CHANGING THE WATER TRAY
See Figure 33.
 Install drain cap.
 Fill the water tray with clean tap water. Ensure the water
level is between "minimum" and "maximum" fill lines.
To change water:
 Unplug the saw.
 Remove the drain cap and empty waste water into a
bucket. Do not allow the water to splash onto the ground
or around the machine.
 Rinse the water tray thoroughly.
 Discard the waste water in accordance with local
regulations.
 Replace the drain cap and refill tray with clean water.
NOTE: Drain fits standard size garden hose.
DRAIN CAP
MAXIMUM
FILL LINE
MINIMUM
FILL LINE
TO CLOSE/OPEN THE WSUV
See Figures 34 - 36.
 Lock sliding table and frame.
 Remove water tray extensions and any workpieces from
the tool.
 Lower the wheel and secure by locking the saw head in
place using the lock knob and lock pin.
LOCK PIN
LOCK
KNOB
WATER
RESERVOIR
Fig. 33
23 — English
STAND
™
RELEASE
LEVER
Fig. 34