RIDGID R4092 Manuel D'utilisation page 28

OPERATION
TO MAKE A CROSS CUT/RIP CUT
See Figure 41.
Cross/rip cuts are straight 90° cuts. The material is fed into
the cut at a 90° angle to the wheel, and the wheel is vertical.
 Using a straight edge or square, draw a line on the tile
with a marker or grease pencil.
 Set the miter guide to 0° for right side or 45° for left side
use. Tighten the lock knob, and lock in place.
 Unlock the frame.
 Place the material on the table and firmly against the miter
guide and fence.
 Make sure the material is clear of the cutting wheel before
turning on the saw.
 Turn the pump switch to position I or II.
 Turn the on/off switch to the ON position.
 Let the cutting wheel build up to full speed and wait for
the wheel to get wet before moving the material into the
wheel.
 Hold the material firmly against the miter guide and fence,
move the sliding table and frame toward the end of the
saw, and slowly feed the material into the cutting wheel.
 When the cut is made, turn the saw OFF. Wait for the
cutting wheel to come to a complete stop before removing
any part of the material.
TO MAKE A DIAGONAL CUT
See Figure 42.
Diagonal cuts are also referred to as "long point-to-long
point cuts".
 Set the miter guide to 45° for right side or 0° for left side
use. Tighten the lock knob, and lock in place.
 Place the material on the table and firmly against the miter
guide and fence.
 Make sure the material is clear of the cutting wheel before
turning on the saw.
 Turn the pump switch to position I or II.
 Turn the on/off switch to the ON position.
 Let the cutting wheel build up to full speed and wait for
the wheel to get wet before moving the material into the
wheel.
 Hold the material firmly against the miter guide and fence,
move the sliding table and frame toward the end of the
saw, and slowly feed the material into the cutting wheel.
 When the cut is made, turn the saw OFF. Wait for the
cutting wheel to come to a complete stop before removing
any part of the material.
28 — English
CROSS CUT/RIP CUT
MARK
SLIDING
TABLE
FENCE
DIAGONAL CUT
MITER
GUIDE
LOCK
KNOB
Fig. 41
Fig. 42