RIDGID R4092 Manuel D'utilisation page 19

ASSEMBLY
TILE CUTTING WHEEL
For maximum performance and safety, it is recommended
that you use the 10 in. cutting wheel provided with your
saw. Additional cutting wheels of the same high quality are
available at your local dealer.
WARNING:
Do not use cutting wheels rated less than the no-
load speed of this tool. Failure to heed this warning
could result in personal injury. Do not use wheel
with cracks, gaps, or teeth.
WARNING:
To prevent possible electrical hazards, have a
qualified electrician check the line if you are not
certain that it is properly wired.
INSTALLING THE CUTTING WHEEL
See Figures 24 and 25.
WARNING:
A 10 in. tile cutting wheel is the maximum wheel
capacity of the saw. Never use a wheel that is too
thick to allow wheel washer to engage with the
flats on the spindle. Larger wheels will come in
contact with the wheel guard, while thicker wheels
will prevent the wheel nut from securing the wheel
on the spindle. Either of these situations could
result in a serious accident and can cause serious
personal injury.
 Unplug the saw.
 Move the sliding table and frame to the front of the saw.
 Loosen wheel guard lock by turning counterclockwise
and open the cutting wheel guard.
 Depress and hold the spindle lock.
 Using the wheel wrench provided, remove the wheel nut.
Release the spindle lock button.
WRENCH
19 — English
SPINDLE
LOCK
TO
TIGHTEN
TO
LOOSEN
WHEEL
WHEEL
GUARD LOCK
Fig. 24