Homelite HCS1835T Manuel D'utilisation page 16

EN
FR DE ES
arm to allow you to resist kickback forces.
Kickback forces can be controlled by the operator,
if proper precautions are taken. Do not let go of the
chain saw. See Figure 11
Do not overreach and do not cut above shoulder
height. This helps prevent unintended tip contact
and enables better control of the chain saw in
unexpected situations.
Only use replacement bars and chains specified
by the manufacturer. Incorrect replacement bars
and chains may cause chain breakage and/or
kickback.
Follow the manufacturer's sharpening and
maintenance instructions for the saw chain.
Decreasing the depth gauge height can lead to
increased kickback.
It is recommended for increased electrical safety to use
a Residual Current Device (RCD) with a tripping current
of not more than 30 mA. Always check your RCD every
time you use it.
The chain saw has a high starting current and should
be connected to a robust power supply. The chain
saw should be connected to a power source with an
consult your electricity provider or authority if necessary.
IT PT NL SV DA
English(Original instructions)
NO FI HU CS RU
13
RO PL SL HR ET LT LV SK BG