Connecting The Loudspeaker Panel And Subwoofer Manually; Programming The Remote Control - Medion LIFE P69042 Mode D'emploi

6.3. Connecting the loudspeaker panel and
subwoofer manually
 The unit must be in standby mode.
 Press the "VOLUME +" button on the top of the loudspeaker panel for 3 seconds.
The operating LED will flash red.
 Press the "PAIR" button on the reverse side of the subwoofer, again keeping the
button pressed for 3 seconds. The PAIR LED will flash blue and purple alternately.
 When both LEDs flash rapidly and then light up red, this indicates that the con-
nection is established.
 If both LEDs continue to flash, this indicates that the connection has not been
established.
NOTE
If the attempt to connect the units fails again, clear the area around the
units of any potential sources of interference (mobile telephones, etc.)
and then repeat the steps listed above.

6.4. Programming the remote control

You can control up to seven functions on your television with the programmable re-
mote control supplied with this product. This means that you will be able to control
your television and the 2.1 sound system with just one remote control.
The following buttons are preassigned at the factory for the operation of a TV:
STANDBY, FUNCTION, ENTER, TV VOL+/VOL-, TV CH+/CH-.
NOTE
The 2.1 Channel Sound Bar with Wireless Subwoofer cannot be operated
by the remote control while it is being programmed.
 Place the remote control (A) about 0.5 to 5 cm away from your TV remote (B).
DE
FR
IT
EN
71 of 76