Scheppach HC 51 Traduction De La Notice Originale page 21

Assembly
Handle
The compressor handle is to be assembled as follows:
Fig. 2
1
Get the two threaded pins from the accessory bag and
put them into the threaded holes in the handle tubes.
2 Push the two handle ends into the fixing holes.
3 Tighten the screws to fix the handle in place.
Wheels, Fig. 3
1 To secure the wheels (12), first place a disc with the
wheel bolts through the wheel. Then, add a disc and
a hex-nut on the inside of the wheel. Now tighten the
nut by hand to the greatest extent that will allow the
wheel to still rotate.
2 Slide the wheel through the clip under the tank.
3 Then fasten it with a disc, a safety glass, and a nut and
tighten them together.
4 Repeat this process for the second wheel.
Rubber feet, Fig. 4
Fix the rubber feet to the bracket on the front of the tank
using the screws, washers and nuts supplied.
Oil, Fig. 5
Warning: For the first use, the compressor must be filled with
oil
In order to prevent a possible spilling of the oil during
transport, the oil is supplied in a separate bin. It must be
filled into the tank before switching the compressor on.
Operating the machine without oil will cause irreparable
damage and render the warranty invalid.
1
Remove the plastic oil inlet plug (14) on top of the
crank box of the compressor casing.
2
Fill the oil supplied into the crank box until the oil
level in the sight glass (16) reaches the centre of the
red circle.
3 Re-attach the oil inlet plug (14) and tighten it firmly.
international 21