Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Figure 3 Shipping spacer wire removal
3.3 Install the instrument
Install this instrument on an indoor wall, away from direct sunlight.
• Use ¼-inch screws to install the instrument.
• For a complete purge of the sample line during each cycle, install the instrument as close to the
sample point as possible.
• Make sure that there is sufficient clearance at the bottom and sides to plumb, wire and operate the
instrument.
Refer to
Figure 4
and
Figure
5.
English 9
Publicité
Table des Matières
