Ryobi ETS-1825 Manuel D'utilisation page 19

ETS-1825 manual 17/06/04
GB
F D E
SPECIFICATION
Saw blade thickness
Max. cutting depth at 90º
Max. cutting depth at 45º
DESCRIPTION
1. TABLE EXTENSION
2. RIP FENCE
3. AUXILIARY FENCE
4. BLADE GUARD
5. RIVING KNIFE
6. MITER GAUGE
7. OUTFEED SUPPORT
8. TABLE
9. BUMPERS
10. PUSH STICK
11. CABINET
12. SWITCH
13. BLADE TILT LOCK LEVER
14. STAND
15. BLADE ADJUST HAND WHEEL
16. FRONT RAIL
17. RIP FENCE LOCKING HANDLE
18. TABLE TILT HANDLE
19. RIP INDICATOR
20. ACCESSORY STORAGE
21. LEVELING FOOT
22. STAND LOCK LEVER
23. OUTFEED ROD
24. SCREW
25. CASTER CAP
26. WASHER
27. CASTER
28. SHOULDER BOLT
29. SCREW WITH WASHER
30. KNOB SCREW
31. NUT
32. WRENCH
33. SAW BLADE
34. SPANNER
35. REAR RAIL
36. REAR LIP
37. 90º BLADE ADJUST SCREW
38. 45º BLADE ADJUST SCREW
39. THROAT PLATE
40. MITRE GAUGE SLOT
41. CLAMP SCREW
13:04 Page 12
I P NL S DK
English
ASSEMBLY
1.8 mm Remove the table saw base, loose parts, and hardware
90 mm from the packing materials. Check all items with the loose
62 mm parts list and drawing.
ASSEMBLING CASTER AND CASTER CAPS
Remove the following hardware from the bag:
- 2 Caster (27)
- 2 Caster cap (25)
- 4 Washers (26)
- 2 Shoulder bolts (28)
■
■
■
■
■
ASSEMBLING BUMPERS (9) (Fig. 3-3)
■
■
ASSEMBLING OUT FEED SUPPORT (7)
Unpack the out feed support assembly and check against
Loose Part List to ensure you have all the parts.
■
■
■
12
N FIN GR H CZ
Place the table saw on end. Secure the axle in the
place by inserting a screwdriver or large nail in the
hole in the center of the axle (Fig. 3-1).
Loosen bolts on each side of the axle by turning
counterclockwise.
Note: To prevent the axle from slipping through the
slots on the table saw, do not remove both bolts at
the same time.
Place a caster and two washers on the shoulder bolt
in the following order: washer, caster, washer
Insert the shoulder bolt, caster, and washers
combination into the axle. Securely tighten.
See (Fig. 3-2).
Place the caster cap in the holes in the caster and tap
the caster cap into place.
Note: The short bolts removed from the axle should
be kept for future use if caster are removed. There
must always be bolts in both sides of the axle for
safe operation.
Place saw table on end.
Securely tighten bumpers in place using the screws.
Insert out feed rod (23) into each out feed bracket,
with the screw-hole end outwards.
Fit a set screw onto each rod (Fig. 4-1).
Place the out feed support on to the rods and secure
with screws (24) and washers (Fig. 4-2).
RUS RO PL