Interventions On The Machine; Replacing Wheels; Replacing A Fuse - EMAK OM 98L/14,5H Manuel D'utilisation

6.3 INTERVENTIONS ON THE MACHINE

6.3.1 Cutting deck alignment
The cutting deck should be properly set to obtain
an evenly cut lawn and reduce vibrations.
If the cut is uneven, check the tyre pressure.
If this is not sufficient to achieve an even cut,
please contact your Dealer who will test and
make the necessary adjustments to the align-
ment of the cutting deck.

6.3.2 Replacing wheels

Stop the machine on flat ground and put a block
under a load-bearing part of the frame on the
side that the wheel is to be changed.
The wheels are held by a snap ring (1) which
can be eased off with a screwdriver.
NOTE
one or both rear wheels, make sure that any
differences in their external diameter does not
exceed 8­10 mm; on the contrary, to prevent
an uneven cut it will be necessary to adjust the
alignment of the cutting deck.
IMPORTANT
wheel, apply grease to the axle. Put the snap
ring (1) and supporting washer (2) back in
place.
2 1
EN 22
If you have to replace
Before remounting the
6.3.3 Replacing and repairing the tyres
The tyres are «Tubeless» and so all punctures
must be repaired by a tyre repairer following the
procedures required for this kind of tyre.
6.3.4 Replacing the bulbs (if present)
The bulbs (18W) have a bayonet fitting and are
installed in the bulb holder which can be taken
out by turning it anti-clockwise with pliers.

6.3.5 Replacing a fuse

The machine is fitted with fuses (1) with different
capacities and functions. Specifically:
– 10 A fuse = protects the main and power cir-
cuits of the electronic board. When it blows,
the machine stops.
– 25 A fuse = protects the battery charger cir-
cuit.When it blows, the battery gradually runs
out and the machine will have problems start-
ing.
1
The fuse capacity is indicated on the fuse.
IMPORTANT
ways be replaced by one of the same type and
ampere rating, and never with one of another
rating.
A blown fuse must al­
1