Cleaning & Maintenance; Glass Replacement - Hergom Manchester Instructions D'installation, De Service Et D'entretien


Improper maintenance of the appliance, which
may result in air infiltration.

Inappropriate fuel that produces high temper-
atures.

Door not closed correctly.
4.4 - REFUELING
It is recommended to wait until only embers remain.
To refuel your appliance, follow these steps:

Open the primary air valve completely, allow-
ing the fire to flare up for at least one minute.

Slightly open the door and keep it in this posi-
tion for about 30 seconds.

Open the door fully.

Spread the embers evenly.

Load the firewood.

Close the door.
If the fire is almost out, you will need to leave the
primary air valve open at the maximum setting to
revive the fire. Once the fire is burning quickly, close
the primary air valve and set it to your desired posi-
tion.
4.5 - FUEL
Use dry firewood and only the recommended fuels:
beech wood, oak wood, fruit tree wood, birch
wood.
Inappropriate fuels: spruce wood, wet wood, chemi-
cally treated wood, wood shavings, pellets, coal. Do
not use wood from marine sources as the salts con-
tained in it react during combustion, releasing acids
that can corrode iron and steel.
WARNING! Your stove should not be used as an in-
cinerator, and other fuels (plastics, particleboard,
etc.) should not be used.
Never use gasoline, lamp fuel (such as gasoline),
kerosene, charcoal lighter fluid, ethyl alcohol, or
similar liquids to start or rekindle the fire. Keep all
these products well away from the appliance while
it is in operation.
5. CLEANING & MAINTENANCE
Your heater is a device that is subjected to extreme
temperatures and to the corrosive effects of combus-
tion residual materials. Regular maintenance is es-
sential for a longer life and improved user experi-
ence.
Refer to sections 4 and 5 of the Professional Installer
Manual (C03406) via the following QR code, where
you will find recommendations for the proper
maintenance and cleaning of the appliance

5.1 - GLASS REPLACEMENT

Use only official Hergom spare parts. Have the glass
replaced through your distributor.
Do not use your stove with a broken door glass.
Do not subject the front door to blows or slamming.
If the door glass breaks, it must be replaced immedi-
ately.
Contact your supplier to order the glass and neces-
sary parts for the repair.
If you replace the glass yourself, wear work gloves
and safety glasses.
The procedure for replacing glass and glass seals is as
follows:
1. Open the door and remove it by loosening the
hinge screws fixed to the door (fig. 11).
2. Place the door upside down horizontally on a
smooth surface.
17
FIG. 11
EN