Replacing The Line Spool; Ordering Replacement Parts; Cleaning And Maintenance; Waste Disposal - EINHELL ROYAL RT 551 Mode D'emploi

Anleitung RT 551 SPK 7
GB
an edge cutter suitable for vertical cutting (Figure
12).

10. Replacing the line spool

Be sure to disconnect the power plug from the power
supply by you replace the line spool!
Press the sides of the spool cover as shown and
remove it with the spool (Figure 13 und Figure
14). Ensure that you do not lose the spring.
Remove the empty line spool.
Thread the ends of the line on the new line spool
through the eyelets in the spool cover.
Fit the spool cover and spool back into the spool
mounting.
When you start the machine again the line will be
cut to the perfect length automatically.
Caution! Catapulted pieces of nylon line may
cause injury!

11. Cleaning and maintenance

Switch off and unplug the grass trimmer before
putting it away or cleaning it.
Remove deposits from the guard hood with a
brush.
Clean the plastic body and plastic parts with a
mild household detergent and a damp cloth.
Never use aggressive agents or solvents for
cleaning purposes!
Never spray down the grass trimmer with water.
Prevent water getting into the trimmer at all cost.
12. Troubleshooting
The machine will not work: Check that the power
cable is connected properly and check the mains
fuses.
If the machine will not work despite the voltage
supply being OK, send it to the specified after-
sales service address.

13. Waste disposal

Important
The grass trimmer and its accessories are made
of various types of material, such as metal and
plastic. Defective components must be disposed
of as special waste. Ask your dealer or your local
council.
14
22.10.2003 8:00 Uhr Seite 14

14. Ordering replacement parts

Please quote the following details when ordering
replacement parts:
Type of machine
Article number of the machine
Serial number of the machine
Replacement part number of the part you require
(Refer to the replacement parts list)