Stihl RCA 20.0 Notice D'emploi page 49

19 Troubleshooting
Error LEDs on the
pressure was‐
her
-
1 LED flashes
red.
-
-
1 LED flashes
red.
The pressure 1 LED lights
washer cuts out up steady red.
during operation.
-
-
Pressure washer -
runtime is too
short.
-
The operating -
pressure fluctua‐
tes or drops.
-
-
-
The shape of the -
water jet has
changed.
-
The pressure -
washer does not
draw in water.
0458-048-9601-A
Cause
The pressure washer
is too warm.
There is an error in
the battery.
No electrical contact
between the pressure
washer and the bat‐
tery
The battery is damp.
There is an error in
the pressure washer.
The pressure washer
is too warm.
The battery is too
warm or too cold.
There is an electrical
error.
The battery is not fully
charged.
The battery life has
been exceeded.
There is not enough
water.
The nozzle is blocked. ► Clean the nozzle.
The water intake
screen or water filter
is blocked.
The pressure washer
is leaking or faulty.
The nozzle is blocked. ► Clean the nozzle.
The nozzle is worn.
The pump does not
generate a vacuum.
Remedy
► Allow the battery to cool down or warm
up.
► Remove the battery.
► Allow the pressure washer to cool down.
► Clean the nozzle.
► Remove the battery and reinsert it.
► Switch on the pressure washer.
► If 1 LED continues to flash red: Do not
use the battery and instead contact a
STIHL authorized dealer.
► Remove the battery.
► Clean the electrical contacts in the bat‐
tery compartment.
► Insert the battery.
► Allow the battery to dry,
► Remove the battery.
► Clean the electrical contacts in the bat‐
tery compartment.
► Insert the battery.
► Switch on the pressure washer.
► If 1 LED continues to flash red: Do not
use the pressure washer and contact a
STIHL authorized dealer.
► Remove the battery.
► Allow the pressure washer to cool down.
► Clean the nozzle.
► Remove the battery.
► Allow the battery to cool down or warm
up.
► Remove the battery and reinsert it.
► Switch on the pressure washer.
► Fully charge the battery.
► Replace the battery.
► Open water tap fully.
► Make sure that a sufficient quantity of
water is available.
► Clean the water intake screen and water
filter.
► Have pressure washer checked by a
STIHL authorized dealer.
► Replace the nozzle.
► Connect the pressure washer to the
water supply.
► Press the trigger until a uniform water jet
flows out of the nozzle.
English
20.6.
49