Specifications - Stihl Rca 20.0 Notice D'emploi

English
Error LEDs on the
pressure was‐
her
Detergent is no -
longer drawn in.
Connectors with
-
pressure washer
or spray lance
are stiff.
19.2 Troubleshooting the Charger
Fault LED on Char‐
ger
Battery not being One LED glows
charged. red.
The LED fla‐
shes red.
The charger The LED
does not run a glows green for
self test. about 1 second
and then red
for about
1 second.
19.3 Greasing the gaskets
1
1
1
► Grease the gaskets (1) with grease suitable
for fixtures.
50
Cause
The container is
empty.
The gaskets of the
connections are not
greased.
Cause
The battery is too
warm or too cold.
No electrical contact
between charger and
battery.
There is a malfunction
in the charger.
There is a fault in the
battery.
Electrical contact to
charger was briefly
interrupted.
1
1
Remedy
► Connect the suction set and draw in
water.
► Fill container with detergent.
► Lubricate the gaskets,
Remedy
► Leave battery inserted in charger.
Charging starts automatically as soon as
the permitted temperature range is rea‐
ched.
► Remove the battery.
► Clean contacts on charger.
► Insert battery.
► Do not use the charger and contact your
STIHL dealer for assistance.
► Do not use the battery. Consult a STIHL
dealer.
► Disconnect the mains plug from the
power supply.
► Wait for 1 minute.
► Insert the mains plug in a wall outlet.

20 Specifications

20.1 STIHL RCA 20.0 Pressure
Washer
– Approved battery: STIHL AS
– Protection class: III
– Max. pressure (p max.): 2.4 MPa (24 bar)
– Max. water supply pressure (p in max.): 1 MPa
(10 bar)
– Max. water throughput (Q max.): 3.9 l/min
(230 l/h)
– Minimum water throughput (Q min.): 2.4 l/min
(140 l/h)
– Max. suction lift: 1.5 m
– Max. water temperature in pressure mode
(t in max): 40 °C
– Max. water temperature in suction mode:
20 °C
– sample inspection
– Length: 329 mm
– Width: 82 mm
– Height: 233 mm
20 Specifications
19.3.
0458-048-9601-A