Operating Levels - Burkert 8032 Manuel D'utilisation

9.2.

operating levels

All settings may influence the correct running of the
process.
• Note the values of the parameters set in the table at chap.
9.8.
The flow threshold detector / flowmeter 8032/8072 has 2 operating
levels: the Process level and the Configuration level.
The Configuration level comprises the Parameters and Test menus.
Operating level Functions
Process • To read out:
- the measured flow rate
- the switching thresholds
- the value of the 4-20 mA output (flowmeter
only)
• To access the Parameters and Test menus of
the Configuration level
28
English
Adjustment and functions
Adjustmentandfunctions
Operating level Functions
Configuration • To make the settings needed for operation:
- Parameters
- flow rate unit
menu
- transistor or relay output
- filter
- bar graph
- K factor
- 4-20 mA current output (flowmeter only)
• To make the following additional settings:
- backlighting
- access code to the Parameters and Test
menus.
Configuration - • To test the configuration made in the Param-
Test menu eters menu with entering of a theoretical value.
• To read the frequency of the measured signal.
• To adjust the 4-20 mA output.