Installation And Wiring; Safety Information - Burkert 8032 Manuel D'utilisation

version type of connector
Detector with Female 5-pin M12 connector (not supplied)
NPN/PNP tran-
sistor output
Detector with EN175301-803 (type 2508 supplied) and 5-pin
relay output M12 (not supplied) female connectors
Flowmeter with EN 175301-803 (type 2508 supplied) and 8-pin
relay output M12 (not supplied) or 5-pin M12 (not supplied)
female connectors
Flowmeter Female 5-pin M12 connector (not supplied)
without relay
output
type of connector cable type
M12 with order code • shielded
917116
• 3 to 6.5 mm in diameter
• with wires with a max. cross section
2508 with order code • shielded
438811
• 6 to 7 mm in diameter
• with wires with a cross section of
14
of 0,75 mm 2
between 0.14 and 0.5 mm
2
English

installation and wiring

Installationandwiring
7. insTAllATion AnD WirinG
7.1.

safety information

danger
risk of injury due to high pressure in the installation
• Stop the circulation of fluid, cut off the pressure and drain the
pipe before loosening the process connections.
risk of injury due to high fluid temperatures.
• Use safety gloves to handle the device.
• Stop the circulation of fluid and drain the pipe before loosening
the process connections.
risk of injury due to the nature of the fluid.
• Respect the regulations on accident prevention and safety relat-
ing to the use of aggressive fluids.
risk of injury due to electrical voltage.
• Shut down the electrical power source of all the conductors and
isolate it before carrying out work on the system.
• Do not unscrew the cover of a powered device.
• Observe all applicable accident protection and safety guidelines
for electrical equipment.